AR
Rigid shaft
The AR series of rigid shafts is used to directly connect parts which are perfectly aligned without any offset.
The main advantages are universal applicability and high reliability.
• Suitable for use in manual and motorized motion transfer.
• Simple and quick installation without additional supports.
• Connecting terminals made of AISI 303 stainless steel - central section made of AISI 304 stainless steel.
• Length on request.
• Available with GC and GCC universal joints to connect shafts which are not aligned and to compensate offsets (➜ 
).
• Available with BT bushings for a rigid connection (➜ 
).
Photogallery
| DIMENSION TABLE | ||||||
 |
||||||
| Version | Length ‹mm› | D1 | ØA | C | B | Coppia ‹Nm› |
| AR08 | ..... | Ø14 | Ø8 | 9 | 2 | 15 |
| AR10 | ..... | Ø22 | Ø10 | 13 | 3 | 30 |
| AR14 | ..... | Ø22 | Ø14 | 19 | 5 | 40 |
| AR20 | ..... | Ø32 | Ø20 | 19 | 6 | 50 |
| COMBINATIONS WITH UNIVERSAL JOINTS | |||||
|
|
|||||
|
COMBINATIONS WITH CONNECTION BUSHES |
|||||
|
|
COUPLING BUSHES 2 piece bushing to couple gearboxes and shafts.
Available bores Ø: 6 - 8 -10 -14.
➜ for more complete information, see BT
GC: cardan joints used for the transmission of torque and movement of non-aligned elements.
• Case entirely machined from solid, in stainless steel AISI303.
• Available bores: ø6 - ø8 - ø10 - ø14.
➜ for more complete information, see sec. "Flexible & semi-rigid shafts..." in the drop-down menu on the left.
